# Without a connection, screenly will not start

**URL:** <https://forums.screenly.io/t/without-a-connection-screenly-will-not-start/632>\
**Category:** Anthias\
**Created:** [October 8, 2021, 5:43am UTC](https://forums.screenly.io/t/without-a-connection-screenly-will-not-start/632 "2021-10-08T05:43:30Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![Marque1968](https://avatars.discourse-cdn.com/v4/letter/m/9fc348/32.png) [@Marque1968](https://forums.screenly.io/u/Marque1968)\
**Post date:** [October 8, 2021, 5:43am UTC](https://forums.screenly.io/t/without-a-connection-screenly-will-not-start/632/1 "2021-10-08T05:43:30Z")

</div>

Due to a crashed SD card I had to reinstall Screenly. But arriving at the location, I couldn’t get it to work, even though it worked at home.

I found that screenly will not start anymore when a network connection is lacking. The Pi is supposed to work on WiFi (which I have troubles to activate up to now). When I am at home and connected by Ethernet cable, the Screenly starts upon booting the system. It shows me the IP-address for connecting and after a while, the loop of images and videos start.

However, when I pull the cable, the page with the IP-address will not show. (In older versions, I got the same page starting that no network IP address was found to reach the backend). Instead I get a white page, that sometimes flickers with a white square in the corner. It might go to black, but will return in white. Only when I connect the ethernet cable, I get the screenly welcome page with the IP-address again.

As soon as I see the IP-address page, I can always disconnect the network, and the system with continue running and showing the photo’s and videos as set.

FYI: The location where this Pi is/was located has no possibility for a network cable. Besides that, the wifi connection is not always pressent. Sceenly must (and always has) function regardless.

As I have been working on this for weeks now, I hope somebody here knows an answer (and perhaps can tell me why the wifi-settings are not accepted either).

Setup:

- Pi 3b (internal wifi)
- Pi OS without desktop
- Screenly OS (admittedly, it was much harder to install to which I remember from a few years ago. the _bash \<(curl_ did not work flawlessly.

---

<div class="post-metadata">

**Author:** ![Marque1968](https://avatars.discourse-cdn.com/v4/letter/m/9fc348/32.png) [@Marque1968](https://forums.screenly.io/u/Marque1968)\
**Post date:** [October 10, 2021, 5:52am UTC](https://forums.screenly.io/t/without-a-connection-screenly-will-not-start/632/2 "2021-10-10T05:52:21Z")

</div>

I managed to do a re-install with a raspberry install of lite, in stead of via the belena etcher. Doing so, solved the problem. I could also connect to the wifi via raspi-config, which wasn’t working before.

Even though I still feel it to be a Screenly related incident upon a networking issue, I can not reproduce it anymore.
